You can attach Magnostream directly to any standard US pipe size  3/4 inch = (20 mm ) water pipe or hose without the need for cutting pipes, using tools, or hiring a plumber. If your pipe has a size of 3⁄4" (20 mm), you may need to secure the Magnostream using the four supplied screws & pre-drilled holes.

Step 1: Pull the two halves of Magnostream a part

Step 2: Align the four red squares so they are facing the same direction (either all facing up or all facing away).

Step 3: Hold one half of the unit and slide it under the pipe.

Step 4: Place the other half on top of the pipe and ensure it clamps down securely.

Use a Philips screwdriver to fit the four screws provided into the pre-drilled holes at each corner of the Magnostream.

Magnostream Pro is designed to fit pipe sizes ranging from ¾ inch to 2 inches. You can add one modular link for each additional inch of pipe diameter, accommodating a maximum of two modular links for a total pipe size of 4 inches.

Step 1 - remove both parts from the packaging, as well as the screws and Allen key provided.

Step 2 - place one half under the pipe and support it with your hand.

Step 3 - still holding the first half, place the second half on top of the pipe and align it with the four vertical screw holes (a).

Step 4 - partly screw in two screws from the top part to secure the unit on the pipe.

Step 5 - swivel the unit round and screw in the remaining two screws; tighten and secure.

To fit an extra modular link, you can follow similar steps to those above but use Allen screws in the four angled screw holes (b).